CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

Redistributing: rip
Default version control: send version 2, receive version 2
Interface Send Recv Triggered RIP Key-chain
FastEthernet0 2 2
Serial0 2 2
Routing for Networks:
172.16.0.0
Routing Information Sources:
Gateway Distance Last Update
172.17.1.2 120 00:13:21
172.16.1.2 120 00:00:24
172.17.0.2 120 00:35:08
Distance: (default is 120)
When will the routes be flushed? 240 seconds
What is the default distance listed for RIP? 120
Task 21: Remove the Version 2 Option for RIP
Remove the version 2 option on the RIP configuration for both routers.
GAD(config)#router rip
GAD(config-router)#no version 2
GAD(config-router)#exit
BHM(config)#router rip
BHM(config-router)#no version 2
BHM(config-router)#exit
Task 22: Show the Routing Table for Router GAD
Show the GAD routing table.
GAD#show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B – BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, * - candidate default
U - per-user static route, o - ODR, P - periodic downloaded static route
T - traffic engineered route
Gateway of last resort is not set
172.16.0.0/24 is subnetted, 3 subnets
C 172.16.0.0 is directly connected, FastEthernet0
C 172.16.1.0 is directly connected, Serial0
R 172.16.3.0 [120/1] via 172.16.1.2, Serial0
Has the output changed now that RIPv2 has been removed? No
Chapter 1: Introduction to Classless Routing 65