CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

xvi Switching Basics and Intermediate Routing CCNA 3 Labs and Study Guide
Curriculum Lab 6-3: Managing the MAC Address Table (6.2.3) 267
Task 1: Configure the Switch 268
Task 2: Configure the Hosts that Are Attached to the Switch 268
Task 3: Verify Connectivity 268
Task 4: Record the Host MAC Addresses 268
Task 5: Determine the MAC Addresses that the Switch Has Learned 268
Task 6: Determine the show mac-address-table Options 269
Task 7: Clear the MAC Address Table 269
Task 8: Verify the Results 270
Task 9: Determine the clear mac-address-table Options 270
Task 10: Examine the MAC Table Again 270
Task 11: Exit the Switch 271
Curriculum Lab 6-4: Configuring Static MAC Addresses (6.2.4) 271
Task 1: Configure the Switch 272
Task 2: Configure the Hosts Attached to the Switch 272
Task 3: Verify Connectivity 272
Task 4: Record the Host MAC Addresses 272
Task 5: Determine the MAC Addresses that the Switch Has Learned 273
Task 6: Determine the mac-address-table Options 273
Task 7: Set Up a Static MAC Address 273
Task 8: Verify the Results 274
Task 9: Remove the Static MAC Entry 274
Task 10: Verify the Results 275
Task 11: Exit the Switch 275
Curriculum Lab 6-5: Configuring Port Security (6.2.5) 275
Task 1: Configure the Switch 276
Task 2: Configure the Hosts Attached to the Switch 276
Task 3: Verify Connectivity 276
Task 4: Record the Hosts’ MAC Addresses 276
Task 5: Determine the MAC Addresses that the Switch Has Learned 277
Task 6: Determine the mac-address-table Options 277
Task 7: Set Up a Static MAC Address 277
Task 8: Verify the Results 278
Task 9: List Port Security Options 278
Task 10: Verify the Results 279
Task 11: Show the Running Configuration File 279
Task 12: Limit the Number of Hosts Per Port 280
Task 13: Configure the Port to Shut Down if a Security Violation Occurs 280
Task 14: Show Port 0/4 Configuration Information 280
Task 15: Reactivate the Port 281
Task 16: Exit the Switch 281
Curriculum Lab 6-6: Add, Move, and Change MAC Addresses (6.2.6)
282
Task 1: Configure the Switch 283
Task 2: Configure the Hosts Attached to the Switch 283