CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

454 Switching Basics and Intermediate Routing CCNA 3 Labs and Study Guide
Step 6. Verify connectivity between all three devices. Each device should be able to ping the other two
devices.
DIST#ping SWA
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.39.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/4/8 ms
DIST#ping SWB
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.39.3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/4 ms
SWB#ping SWA
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.39.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/4 ms
Task 7: Verify Inter-VLAN Routing
Step 1. Attach two workstations to different VLANs.
Step 2. Verify that each workstation received an IP address from the DHCP server on DIST.
Step 3. Verify that the two workstations can ping each other. Traceroute should show that the ping
packets are going through the router. The following is some sample output of this verification.
Yours should look similar.
——————————————————————————-
Configuration for a Workstation attached to VLAN 10
——————————————————————————-
C:\>ipconfig
Windows IP Configuration
Ethernet adapter Local Area Connection:
Connection-specific DNS Suffix . :
IP Address. . . . . . . . . . . . : 172.16.32.11
Subnet Mask . . . . . . . . . . . : 255.255.252.0
Default Gateway . . . . . . . . . : 172.16.32.1
——————————————————————————-
Configuration for a Workstation attached to VLAN 20
——————————————————————————-
C:\>ipconfig