CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

194 Switching Basics and Intermediate Routing CCNA 3 Labs and Study Guide
Lab Exercises
Command Reference
In the table that follows, record the command, including the correct router prompt, that fits the description.
Fill in any blanks with the appropriate missing information.
Command Description
Router(config)#router eigrp 100 Turns on the EIGRP process.
100 is the autonomous system (AS) number,
which can be a number between 1 and 65535.
All routers in the same AS must use the same
AS number.
Router(config-router)#eigrp log-neighbor-changes Logs any changes to an EIGRP neighbor
adjacency.
Router(config-router)#no auto-summary Turns off the automatic summarization of
networks at classful boundaries.
Router(config-if)#bandwidth 128 Changes the bandwidth of an interface to
128 kbps.
Router(config-if)#ip summary-address Enables manual summarization on this specific
eigrp 100 10.10.0.0 255.255.0.0 interface for the 10.10.0.0/16 address space.
Router#show ip eigrp neighbors Displays a neighbor table.
Router#show ip eigrp neighbors detail Displays a detailed neighbor table.
Router#show ip eigrp interface Displays EIGRP information for each interface.
Router#show ip eigrp topology Displays the topology table. This command
shows you where your feasible successors are.
Router#show ip eigrp traffic Displays the number and type of packets sent
and received.
Router#debug eigrp fsm Displays events/actions related to the DUAL
FSM.
Router#debug eigrp packet Displays events/actions related to EIGRP packets.
Router#debug eigrp neighbor Displays events/actions related to EIGRP neighbors.