CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

434 Switching Basics and Intermediate Routing CCNA 3 Labs and Study Guide
VTP Pruning Mode : Disabled
VTP V2 Mode : Disabled
VTP Traps Generation : Disabled
MD5 digest : 0x57 0xCD 0x40 0x65 0x63 0x59 0x47 0xBD
Configuration last modified by 0.0.0.0 at 0-0-00 00:00:00
Local updater ID is 10.1.0.3 on interface Vl1 (lowest numbered VLAN interface
found)
Step 6. Enter the commands to configure SWB as a VTP client on the CCNA3 VTP domain with the
password cisco. Record the commands you used.
SWB(config)#vtp mode client
Setting device to VTP CLIENT mode.
SWB(config)#vtp domain CCNA3
Changing VTP domain name from NULL to CCNA3
SWB(config)#vtp password cisco
Setting device VLAN database password to cisco
Step 7. It may take a while for SWB to receive a VTP message from the server, because, unless there
is a change or unless a request is made, the server sends out VTP advertisements only every 5
minutes. You can speed up the process by shutting down the trunks attached to SWA and then
reactivating them. This will force an exchange of VTP messages. Verify SWB now has the
VLAN information from SWA.
SWB#show vtp status
VTP Version : 2
Configuration Revision : 3
Maximum VLANs supported locally : 64
Number of existing VLANs : 8
VTP Operating Mode : Client
VTP Domain Name : CCNA3
VTP Pruning Mode : Disabled
VTP V2 Mode : Disabled
VTP Traps Generation : Disabled
MD5 digest : 0x3B 0x01 0x37 0x7F 0x25 0x20 0xD0 0x0F
Configuration last modified by 0.0.0.0 at 3-1-93 00:30:56
SWB#show vlan brief
VLAN Name Status Ports
—— ———————————————— ————- ———————————————-
1 default active Fa0/1
10 Accounting active Fa0/4, Fa0/5, Fa0/6, Fa0/7
Fa0/8
20 Marketing active Fa0/9, Fa0/10, Fa0/11,
Fa0/12
Fa0/13, Fa0/14, Fa0/15,
Fa0/16
30 Purchasing
Fa0/24
active Fa0/17, Fa0/18, Fa0/19,
Fa0/20
Fa0/21, Fa0/22, Fa0/23,
1002 fddi-default active
1003 token-ring-default active
1004 fddinet-default active
1005 trnet-default active