CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

66 Switching Basics and Intermediate Routing CCNA 3 Labs and Study Guide
Task 23: Show the Routing Table for Router BHM
Step 1. Show the BHM routing table.
BHM#show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B – BGP
area
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is not set
172.16.0.0/24 is subnetted, 3 subnets
R 172.16.0.0 [120/1] via 172.16.1.1, 00:00:01, Serial0
C 172.16.1.0 is directly connected, Serial0
C 172.16.3.0 is directly connected, Ethernet0
Has the output changed now that RIPv2 has been removed? No
Step 2. Upon completion of the previous step, log off (by typing exit) and turn the router off. Then,
remove and store the cables and adapter.
Curriculum Lab 1-5: Troubleshooting RIPv2 Using debug
(1.2.6)
Figure 1-35 Topology for Lab 1-5
Straight-Through Cable
Table 1-14 Lab Equipment Configuration
Router Designation Router Name Fast Ethernet 0 Address Interface Type
Serial 0 Address
Router 1 GAD 172.16.0.1 DCE 172.17.1.1
Router 2 BHM 172.18.0.1 DTE 172.17.1.2
The enable secret password for both routers is class.
Router 1 Router 2
Rollover (Console) Cable
Crossover Cable
Serial Cable