CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

Equipment
The topology shown in Figure 2-16 is using 2600 series routers. This lab can be done with any combination
of 1700, 2500, and 2600 series routers. Connectivity to an ISP is simulated with a loopback interface
on RTA.
NetLab Compatibility Notes
This lab is fully compatible with a standard NetLab three router pod.
Task 1: Cable the Topology and Basic Configurations
Step 1. Cable the topology as shown. If DCE/DTE connections and interfaces are different from those
shown in Figure 2-16 and the table, relabel the figure to match your connections.
Step 2. Configure the routers with basic router configurations, including
■ Hostnames and host tables
■ Enable secret password and MOTD banner
■ Line configurations
■ IOS-specific commands (e.g. ip subnet-zero with IOS versions prior to 12)
Step 3. The following is a basic configuration for RTA:
Router(config)#hostname RTA
RTA(config)#ip subnet-zero
RTA(config)#no ip domain-lookup
RTA(config)#ip host RTC 192.168.1.253 192.168.1.254
RTA(config)#ip host RTB 192.168.1.246 192.168.1.249
RTA(config)#banner motd &
***********************************
!!!AUTHORIZED ACCESS ONLY!!!
***********************************
&
RTA(config)#line con 0
RTA(config-line)#exec-timeout 30 0
RTA(config-line)#password cisco
RTA(config-line)#logging synchronous
RTA(config-line)#login
RTA(config-line)#line aux 0
RTA(config-line)#exec-timeout 30 0
RTA(config-line)#password cisco
RTA(config-line)#logging synchronous
RTA(config-line)#login
RTA(config-line)#line vty 0 4
RTA(config-line)#exec-timeout 30 0
RTA(config-line)#password cisco
RTA(config-line)#logging synchronous
RTA(config-line)#login
RTA(config-line)#end
RTA#copy run start
Chapter 2: Single-Area OSPF 157