CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

Task 2: Configure the Area 0 OSPF Routers
On the routers, enter global configuration mode and configure the hostname, console, virtual terminal, and
enable passwords. Next, configure the interfaces and IP hostnames according to the Lab Equipment
Configuration tables, Tables 2-12 and 2-13. If you have problems configuring the router basics, refer to
Lab 1-2, “Review of Basic Router Configuring with RIP.”
Note: Do not configure the routing protocol until you are specifically told to.
Tokyo
Router>enable
Router#configure terminal
Router(config)#hostname Tokyo
Tokyo(config)#enable secret class
Tokyo(config)#line console 0
Tokyo(config-line)#password cisco
Tokyo(config-line)#login
Tokyo(config-line)#line vty 0 4
Tokyo(config-line)#password cisco
Tokyo(config-line)#login
Tokyo(config-line)#exit
Tokyo(config)#interface loopback 0
Tokyo(config-if)#ip address 192.168.31.11 255.255.255.255
Tokyo(config-if)#interface serial 0
Tokyo(config-if)#ip address 192.168.1.1 255.255.255.252
Tokyo(config-if)#clockrate 64000
Tokyo(config-if)#no shutdown
Tokyo(config-if)#interface fastethernet 0
Tokyo(config-if)#ip address 192.168.1.129 255.255.255.192
Tokyo(config-if)#no shutdown
Tokyo(config-if)#exit
Tokyo(config)#ip host Madrid 192.168.0.1 192.168.1.2
Tokyo(config)#exit
Madrid
Router>enable
Router#configure terminal
Router(config)#hostname Madrid
Madrid(config)#enable secret class
Madrid(config)#line console 0
Madrid(config-line)#password cisco
Madrid(config-line)#login
Madrid(config-line)#line vty 0 4
Madrid(config-line)#password cisco
Madrid(config-line)#login
Madrid(config-line)#exit
Madrid(config)#interface loopback 0
Madrid(config-if)#ip address 192.168.31.22 255.255.255.255
Chapter 2: Single-Area OSPF 151