CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

436 Switching Basics and Intermediate Routing CCNA 3 Labs and Study Guide
Workstation attached to SWA:
Port __________
VLAN __________
IP address ________________
Subnet mask _______________
Workstation attached to SWB:
Port __________
VLAN __________
IP address ________________
Subnet mask _______________
Step 4. Verify that the two workstations can ping each other. If they cannot, troubleshoot.
Task 4: Adding, Moving, and Deleting VLANs
Step 1. A few employees from the Warehousing department are relocating to the office serviced by the
SWB switch. Create a new VLAN 40 named Warehousing. Record the commands, including
switch prompt, to create this new VLAN.
SWA(config)#vlan 40
SWA(config-vlan)#name Warehousing
Step 2. Verify that SWB has incremented its VTP configuration revision number and has the new
VLAN listed.
SWB#show vtp status
VTP Version : 2
Configuration Revision : 4
Maximum VLANs supported locally : 64
Number of existing VLANs : 9
VTP Operating Mode : Client
VTP Domain Name : CCNA3
VTP Pruning Mode : Disabled
VTP V2 Mode : Disabled
VTP Traps Generation : Disabled
MD5 digest : 0xBC 0xD2 0x4A 0x5B 0xF3 0x03 0x26 0x75
Configuration last modified by 10.1.0.2 at 3-1-93 01:17:40
SWB#show vlan brief
VLAN Name Status Ports
—— ———————————————— ————- ———————————————-
1 default active Fa0/1
10 Accounting active Fa0/4, Fa0/5, Fa0/6, Fa0/7
Fa0/8
20 Marketing active Fa0/9, Fa0/10, Fa0/11, Fa0/12
Fa0/13, Fa0/14, Fa0/15, Fa0/16
30 Purchasing active Fa0/17, Fa0/18, Fa0/19, Fa0/20
Fa0/21, Fa0/22, Fa0/23, Fa0/24