CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

Lab Exercises
Command Reference
In the table that follows, record the command, including the correct switch prompt, that fits the description
for a 1900 Catalyst switch.
1900 Switch Command Description
Switch(config)#interface fa 0/26
Switch(config-if)#trunk on Turns port to trunking mode
Switch#show trunk A Displays trunking information about port 0/26, which is
trunk A
Switch(config)#vtp client Changes the switch to client mode
Switch(config)#vtp server Changes the switch to server mode
Switch(config)#vtp transparent Changes the switch to transparent mode
Switch(config)#vtp domain CCNA3 Sets the name of the VTP management domain to CCNA3
Switch(config)#vtp password cisco Set the VTP password to cisco
Switch#show vtp Displays all VTP information
In the table that follows, record the command, including the correct switch prompt, that fits the description
for a 2900 Catalyst switch. When appropriate, use VLAN database configuration mode.
2900 Switch Command Description
Switch(config)#interface fa 0/1
Switch(config-if)#switchport mode trunk Turns port to trunking mode
Switch(config-if)#switchport trunk encapsulation isl Sets encapsulation type to ISL
Switch(config-if)#switchport trunk encapsulation dot1q Sets encapsulation type to Dot1Q—
the default encapsulation type
Switch#vlan database Enters VLAN database mode
Switch(vlan)#vtp client Changes the switch to client mode
Switch(vlan)#vtp server Changes the switch to server mode
Switch(vlan)#vtp transparent Changes the switch to transparent mode
Switch(vlan)#vtp domain CCNA3 Sets the name of the VTP management
domain to CCNA3
Switch(vlan)#vtp password cisco Set the VTP password to cisco
Switch(vlan)#vtp v2-mode Sets VTP mode to version 2
Switch(vlan)#vtp pruning Enables VTP pruning
Chapter 9: VLAN Trunking Protocol 389
Switch(vlan)#exit Applies the VLAN database changes and
exits the mode