CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

258 Switching Basics and Intermediate Routing CCNA 3 Labs and Study Guide
interface FastEthernet0/19
no ip address
!
interface FastEthernet0/20
no ip address
!
interface FastEthernet0/21
no ip address
!
interface FastEthernet0/22
no ip address
!
interface FastEthernet0/23
no ip address
!
interface FastEthernet0/24
no ip address
!
interface Vlan1
no ip address
no ip route-cache
shutdown
!
ip http server
!
!
line con 0
line vty 5 15
!
end
Switch#
Step 2. Examine the current contents of NVRAM.
Switch#show startup-config
startup-config is not present
Why does the switch give this response?
Nothing is saved into NVRAM.
Task 3: Assign a Name to the Switch
Step 1. Enter enable and then configuration mode. Configuration mode allows the management of the
switch. Enter the name by which this switch will be referred, ALSwitch.
Switch#configure terminal
Enter configuration commands, one per line. End with Ctrl+Z.
Switch(config)#hostname ALSwitch
ALSwitch(config)#exit
Step 2. Notice that the prompt changed to reflect its new name. Type exit or press Ctrl-Z to go back
into privileged mode.