CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

x Switching Basics and Intermediate Routing CCNA 3 Labs and Study Guide
Task 4: Configure the Routing Protocol on Router BHM 67
Task 5: Save the BHM Router Configuration 68
Task 6: Configure the Hosts 68
Task 7: Verify the Internetwork Is Functioning 68
Task 8: Show the debug ip Command Options 68
Task 9: Show the debug ip rip Command Options 69
Task 10: Show the RIP Routing Updates 69
Task 11: Enable RIPv2 Routing on Router GAD Only 69
Task 12: Restart the Debug Function on Router GAD 69
Task 13: Clear the Routing Table 70
Task 14: Start the Debug RIP Function 70
Task 15: Clear the Routing Table 70
Task 16: Enable RIPv2 Routing on Router BHM 71
Task 17: Use the Debug Function to See Packet Traffic on a Router 71
Task 18: Start the debug ip rip database Function on Router BHM 71
Task 19: Use the Debug Function to See Routing Updates 71
Comprehensive Lab 1-6: Default Routing and RIPv2 72
Task 1: Cable the Topology and Basic Configurations 73
Task 2: Configure Interfaces and Enable RIPv2 74
Task 3: Verify Connectivity 75
Task 4: Add ISP Router 76
Task 5: Configure Static and Default Routing 77
Task 6: Verify Connectivity and Capture Scripts 77
Challenge Lab 1-7: VLSM Design, RIPv2, and Default Routing 85
Task 1: Design the Addressing Scheme 86
Task 2: Cable the Topology and Basic Configurations 87
Task 3: Configure the Interfaces and Enable RIPv2 87
Task 4: Configure Static and Default Routing 87
Task 5: Verify Connectivity 88
Task 6: Challenge 89
Chapter 2: Single-Area OSPF 99
Study Guide 100
Link-State Routing Overview 100
Vocabulary Exercise: Matching 100
Vocabulary Exercise: Completion 101
Compare and Contrast Exercise 101
Concept Questions 102
Journal Entry 102
Single-Area OSPF Concepts 102
Vocabulary Exercise: Completion 102
Build the SPF Loop-Free Topology 103
Concept Questions 106
Single-Area OSPF Configuration 106
Learn the OSPF Commands Exercise 107