LTI TRUCAM LASER MEASUREMENT DEVICE - Tele-Traffic
LTI TRUCAM LASER MEASUREMENT DEVICE - Tele-Traffic
LTI TRUCAM LASER MEASUREMENT DEVICE - Tele-Traffic
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Weather Mode<br />
Moisture is reflective. Weather such as rain, snow, mist, spray or fog can make it difficult for the laser<br />
to receive signals back from the target vehicle. This is especially true when you are trying to capture<br />
speeds at close range. The TruCAM includes a built-in Weather Filter that, when it is active, it is applied<br />
when the laser is fired.<br />
When the Weather Mode is active, the factory-defined gate setting increases the instrument’s minimum<br />
range from 20 metres to 61 metres. Increasing the minimum range ensures that the laser only acquires<br />
targets beyond the range where weather affects the laser’s ability to capture a speed reading.<br />
When this filter is active:<br />
1. The icon is displayed at the top of the Touch Screen as<br />
Figure 47 shows.<br />
2. Targets must be a distance greater than 61 metres.<br />
3. The instrument’s maximum range is not changed.<br />
4. Other than the above items, the TruCAM operates the same as when<br />
the Weather Mode is not active.<br />
To activate the Weather Mode<br />
1. Ensure that the TruCAM is powered ON and that the Capture Mode is<br />
active.<br />
2. Tap to display the other options on the Caption Session Toolbar.<br />
3. Tap or press the soft key to activate the Weather Filter.<br />
4. Proceed<br />
<br />
with making a normal speed measurement as described on<br />
the previous page.<br />
Rear Plate Mode<br />
Rear Plate Mode can be used when targeting an approaching motorcycle<br />
or other vehicle that does not have a front Licence plate.<br />
The process of measuring the speed and distance is the same as in<br />
the Speed Mode. The difference is that in this mode, after the speed<br />
measurement has been taken, continue to hold the TRIGGER and track<br />
the vehicle as it passes.<br />
Keep the camera on the target until it is on the rear Licence plate and then<br />
release the TRIGGER. The still image is captured when you release the<br />
TRIGGER.<br />
When this mode is active the icon is displayed at the top of the LCD Touch Screen as Figure 48<br />
shows.<br />
<br />
To start the Rear Plate Mode, tap or press the soft key.<br />
<br />
• Image quality may be poor if the target vehicle is not in the camera focus or range when you release<br />
the TRIGGER.<br />
• In this mode, target vehicles will always be approaching, therefore, all measured speeds will be<br />
positive values.<br />
38<br />
Figure 47<br />
Figure 48<br />
© <strong>Tele</strong>-<strong>Traffic</strong> UK Ltd 2011