manual de instalação e utilização transmissor console ... - Usicontrol

There are also two LEDs in the received which will describe the status of the CAN-BUS. If the
CAN connection is not working, check the status of next LEDs:
LED LIT FLASHING OFF
CAN_RUN Operating status Pre-operating status CAN
active
communication non
CAN_ERR Communication OK
Communication error
CAN controller disconnected
If the problem is associated with the equipment, please send both the transmitter and the
receiver to the your Technical Assistance Service Agent, together with a description of the
problem and the status of the LED‘s.
If the transmitter becomes so damaged that a spare has to be arranged, it can be quickly
substituted by following the instructions in ANNEX A.
TM70Pi V3.2 (11/02) 120021.pdf. 13
IKUSI reserves the right to change this information without prior notice.