manual de instalação e utilização transmissor console ... - Usicontrol

21.1 - INTRODUCTION
Access to this option can be activated or deactivated by EEPROM, by EEPROM recorder and/or TM70Config, if
it is connected in the expansion the Jumper which enables Tele-alignment. Cards that support Tele-Alignment
are:
A1P4RCAN(1 relay based potentiometric output card)
A2VCAN (2 voltage analogue output card)
A2ICAN (2 PWM current analogue outputs card)
A2ICAN and A2VCAN expansion cards are interchangeable, but the position and number of outputs will be
the same, also will require a modification of EEPROM due to differences in the output parameters. The new
expansion will be automatically recognized by the system. At the time of accessing to the Tele-Alignment menu,
the system makes a recognition of all the expansions connected to the CAN bus and supported outputs. All
information is synchronized between the transmitter and receiver.
The Tele-Alignment process requires the use of display LCD70 option (soft. version 3.1 or higher) or the TM70
Tele-Teaching support module (IKUSI Ref. 2305120-00A) designed for that purpose.
21.2 – TELE-ALIGNMENT PROCESS
The navigation through the software will be done by using the ▲ "UP" ▼ "DOWN", ENTER (validate selection)
and "ESC" (abort selection) keys, but are configurable by EEPROM and/or TM70Config. In situations where you
would press "UP" or "DOWN" repeatedly, there is a progressive move by holding down the key.
To access the Tele-Alignment menu must be pressed in sequence the "ENTER" (default) + "START".
This configuration is defined by EEPROM, but ENTER function may be replaced by any other manoeuvre by
TM70Config to change the access sequence to the Tele-Alignment menu.
The default menus are in English, but you can choose between English and Spanish by EEPROM and/or
TM70Config or Menu option (5. SELECT LANGUAGE).
TM70Pi V3.2 (11/02) 120021.pdf. 91
IKUSI reserves the right to change this information without prior notice.