manual de instalação e utilização transmissor console ... - Usicontrol

Transmitters do not need selectors. The receiver is the one that Frees its ID code.
When a Pitch & Catch operation needs to be performed, the user of the transmitter that wants to
Catch the crane must ask the user holding the crane to release the crane. The procedure is the
following: The owner of the crane must press the STOP button while the user that wants to Catch
the crane must be pressing the START button. The receiver will free the ID code and will SCAN new
ID codes and new channels, if in the lapse of time of a passive STOP, it encounters the new ID it will
keep on going without falling the STOP relays.
In the event that the transmitter governing the crane stops while the second transmitter is switched
off, the system will STOP normally and will be free until one transmitter with a valid ID presses the
START button.
When a Pitch & Catch operation is finished, the first transmitter to press START will get hold of the
crane.
This mode of operation is personalised in the remote control EEPROM and must be done by IKUSI
personnel only.
TM70Pi V3.2 (11/02) 120021.pdf. 54
IKUSI reserves the right to change this information without prior notice.