manual de instalação e utilização transmissor console ... - Usicontrol

13.2 - ONE MASTER TRANSMITTER SYSTEMS
ID1
ID2
F1
RECEIVER 1
SLAVE
F1
F2
The Master Transmitter has got a crane selector ―1 / 1+2 / 2‖, while the slave transmitter has only
got a release ―R‖ push button.
When a tandem operation is needed, the operator of the master transmitter must require the slave
transmitter operator the liberation of receiver 1. In order to do it, it has to be pressed simultaneously
the release ―R‖ push button and the Start button. The transmitter will send receiver 1 the liberation
order, remaining like that disconnected and ready to accept a new ID code.
When arriving to this stage, the position ―1+2‖ may be selected in the master transmitter and then
press the Start button until the Green LED is switched on. By doing this, the transmitter will send the
liberation order to receiver 2 and following that, it will send the new ID code. Both receivers, 1 and 2,
will then be started and ready to tandem operation.
When tandem operation has finished, the master transmitter must select position 2 again and press
the Start button. By doing this, receiver 1 is again ready to be used by the slave transmitter, and the
master transmitter only controls receiver 2.
TM70Pi V3.2 (11/02) 120021.pdf. 57
IKUSI reserves the right to change this information without prior notice.
F2
ID1 ID2
ID2
RECEIVER 2
MASTER
F2
F2