manual de instalação e utilização transmissor console ... - Usicontrol

More documents

Recommendations

Info

The received display commands will be 8 bytes grouped frames. If the length of the frame is higher the radio remote receiver will split the data in 8 bytes data frames. For the radio remote receiver the received data are transparent; the receiver does not process the information. 8.6 -RECEIVER‟S SIGNALLING The receiver is furnished with two signalling LEDs, controlled according to CIA DR-303-3 recommendation: CAN-RUN (green): indicates the system state insi<strong>de</strong> the CANopen machine state: Blinking every 200 ms. In preoperational state. Solid green permanently in operational state. One blink every second in stop state. CAN-ERR (red): indicates error if switched on; in normal conditions it must be switched off. 8.7 - TM70 CAN RECEIVERS Ref. 3302750 (7503 70GR401 RX R70CANC3 433) Ref. 3302751 (7504 70GR903 RX R70CANC3 915) 70GR902 RX-RCANNOCE Ref. 3302626 Specifications Available frecuencies (ISM bands) 915MHz (FCC certified) 433MHz Power supply / Maximum consumption 9-35v DC / 5W maximum Inputs / Outputs interface CAN:Standard CAN Open protocol 401 (CIA DS401) Ingress protection IP67 / NEMA-6 Antenna External: NEARSON S325TR-015 or equivalent Working frequency selection Automatic: LBT (listen before talking) Weight 430 gr. Dimensions Long = 151mm / Width = 129mm (160mm with PG) / Height = 61mm EEPROM Extractable EP70 module Signalling MultiLED: 7 external LEDS (6 green + 1 bicoloured) 2 internal LEDS (CAN status: 1 red + 1 green) Connexions Fast PLUG-IN plugs and 2 x M16 cable glands 1) Power supply cable gland: M16 / IP67 2) Inputs / Outputs interface cable gland: M16 / IP67 STOP function Cat. 3 EN-954-1 / 2 STOP relays: 250V / 6A maximum STOP response time = 50 miliseconds CAN BUS termination (120 Ohm) ON / OFF jumper (internal) Passive STOP time Programmable: 0,5 to 2 seconds (máx) Input protection PTC / 0,3A fuse Output protections (STOP) VDR in contacts Operating mo<strong>de</strong> temperatura range -20ºC / +70ºC (-4ºF / 158ºF) Storage temperatura (24h) -25ºC / +75ºC (-13ºF / 167ºF) Storage temperature –long periods- -25ºC / +55ºC (-13ºF / 131ºF) TM70 range supported transmitters T70/1/2; T70/3/4; T70/5/6; T70/7/8 TM70Pi V3.2 (11/02) 120021.pdf. 24 IKUSI reserves the right to change this information without prior notice.
Connections scheme : Receiver‟s dimensions in milimeters: It is also available the option Ref. IKUSI 3302620 ―Fast fixation kit‖, including a set of 4 magnets and 4 shock absorbers TM70Pi V3.2 (11/02) 120021.pdf. 25 IKUSI reserves the right to change this information without prior notice.
Page 1 and 2:
MANUAL DE INSTALAÇÃO E UTILIZAÇ
Page 3 and 4:
11.- OPÇÃO LIMITADOR DE ALCANCE L
Page 5 and 6:
1.- DECLARAÇÃO DE CONFORMIDADE (B
Page 7 and 8:
3.- DESCRIÇÃO DO SISTEMA Os contr
Page 9 and 10:
4.3 - RECOMENDACIONES FCC (Sólo v
Page 11 and 12:
5.2 - RECEPTOR Promover a parada to
Page 13 and 14:
5.3- INÍCIO DE OPERAÇÃO Seja pre
Page 15 and 16:
6.- UTILIZAÇÃO Para uma correta u
Page 17 and 18:
7.3 - LOCALIZAÇÃO DE AVARIAS O em
Page 19 and 20:
ANEXO A - PROGRAMAÇÃO DO EMISSOR
Page 21 and 22:
ANEXO C - MUDANÇA DE CANAL BASE. O
Page 23 and 24:
8.1 - INTRODUCCIÓN El equipo TM70
Page 25 and 26:
100D: LIFE TIME FACTOR 1014: COB-ID
Page 27 and 28:
8.5 - DICCIONARIO DE DATOS DEL RECE
Page 29 and 30:
8.6 - SEÑALIZACIÓN El receptor di
Page 31 and 32:
Mantenimiento y localización de er
Page 33 and 34:
9.1 - INTRODUCCIÓN y DESCRIPCION F
Page 35 and 36:
9.3 - EXPLOSIONADO DE ENSAMBLAJE T7
Page 37 and 38:
9.5 - MODO RETORNO DE INFORMACION L
Page 39 and 40:
9.5.2 ICONOS DISPONIBLES Los iconos
Page 41 and 42:
Ejemplo: Retorno CAN VT100 Escribir
Page 43 and 44:
Una vez completados los 24 caracter
Page 45 and 46:
10. TM70 - OPERACIONES EN MODO FIRS
Page 47 and 48:
11.1.1- DESCRIPCIÓN DEL SISTEMA Lo
Page 49 and 50:
11.2.2 - INSTALACION Y CONEXIONADO
Page 51 and 52:
11.3.1 - EMISOR INFRARROJO LA70M Nu
Page 53 and 54:
Area de cobertura elíptica de la e
Page 55 and 56:
12.- MODO DE FUNCIONAMIENTO “PITC
Page 57 and 58:
Los emisores no disponen de ningún
Page 59 and 60:
13. TM70 - OPERACIONES EN TANDEM 13
Page 61 and 62:
13.3.- SISTEMAS CON DOS EMISORES MA
Page 63 and 64:
14. TM70 - OPERACIONES CON VIA DE R
Page 65 and 66:
14.3- MONTAJE EXPANSION IN0-10V CON
Page 67 and 68:
15.1 - INTRODUCCIÓN y DESCRIPCION
Page 69 and 70:
16.- OPCION IN4D OPCION IN4D TM70 T
Page 71 and 72:
En caso de no disponer una tensión
Page 73 and 74:
16.2.- CONEXIÓN CON LR71 y LR72 2.
Page 75 and 76:
17.1- INTRODUCCION y DESCRIPCION FU
Page 77 and 78:
18.- OPCION A1P4RCAN OPCION A1P4RCA
Page 79 and 80:
SALIDAS DE RELÉS RL2 RL3 +VI GND 1
Page 81 and 82:
19.- OPCION A2ICAN OPCION A2ICAN TM
Page 83 and 84:
La velocidad de rampa se define par
Page 85 and 86: JUMPERS DE CONFIGURACION Tamaño ¼
Page 87 and 88: 20.1- INTRODUCCIÓN Y DESCRIPCIÓN
Page 89 and 90: El rango de los valores de salida o
Page 91 and 92: 20.3- TARJETA DE ALIMENTACIÓN DE E
Page 93 and 94: 21.1- INTRODUCCIÓN El acceso a est
Page 95 and 96: (*) SI FREQ. PWM = 0 (ALTA FRECUENC
Page 97 and 98: VALORES LIMIT: Ajuste de los valore
Page 99 and 100: 21.2.2- MENU 3.2 VAL. FÁBRICA: Imp
Page 101 and 102: 22.1 - CARACTERISTICAS PRINCIPALES
Page 103 and 104: OPCION 4: Relación de tipos de exp
Page 105 and 106: 22.2 - OBSERVACIONES PARA EL CABLEA
Page 107 and 108: CHINA 北京市朝阳区望京阜
Page 109 and 110: I N D I C E 1.- DECLARATION OF CONF
Page 111 and 112: TM70Pi V3.2 (11/02) 120021.pdf. iii
Page 113 and 114: 2. - DECLARATION OF CONFORMITY (433
Page 115 and 116: 4.- SAFETY INSTRUCTIONS These instr
Page 117 and 118: 5.- INSTALLATION 5.1 - CB70 (BC70K)
Page 119 and 120: Connect the power supply and the re
Page 121 and 122: Next, turn transmitter ON to OPERAT
Page 123 and 124: 7.- MAINTENANCE 7.1 - WARRANTY 7.2
Page 125 and 126: There are also two LEDs in the rece
Page 127 and 128: ANNEX B.- PROGRAMMING THE MACHINE I
Page 129 and 130: 8.- CAN OPEN INTERFACE V 2.4 CANope
Page 131 and 132: The LED signalling is the one recom
Page 133 and 134: 8.4 - PUSHBUTTONS AND CONSOLE BOX P
Page 135: CONSOLE BOX: The receiver can accep
Page 139 and 140: 9.- LCD70 DISPLAY OPTION LCD70 DISP
Page 141 and 142: 9.2 - INTERNAL CONNECTION POWER SUP
Page 143 and 144: TM70Pi V3.2 (11/02) 120021.pdf. 31
Page 145 and 146: 9.5 - DATA FEEDBACK OPERATING MODE
Page 147 and 148: 9.5.2 AVAILABLE ICONS: The availabl
Page 149 and 150: Example: VT100 data feedback Write
Page 151 and 152: Once that we have completed the 24
Page 153 and 154: TM70 - “FIRST COME - FIRST SERVED
Page 155 and 156: 11.1.1 - SYSTEM DESCRIPTION TM70 ra
Page 157 and 158: In cases in which it is believed th
Page 159 and 160: In cases in which the area covered
Page 161 and 162: Module: LA70M EX SPECIFICATIONS DC
Page 163 and 164: 11.3.2.- LA70M INSTALLATION AND CON
Page 165 and 166: TM70 - “PITCH & CATCH” OPERATIO
Page 167 and 168: 13.- TANDEM OPERATION TANDEM OPERAT
Page 169 and 170: 13.2 - ONE MASTER TRANSMITTER SYSTE
Page 171 and 172: 14.- ANALOGUE FEEDBACK / IN 0-10V O
Page 173 and 174: 8. Press ―ENTER‖ function. 9. I
Page 175 and 176: 15.- IN0450P OPTION IN0450P OPTION
Page 177 and 178: 15.2 - IN0450P and LR70 ASSEMBLY IN
Page 179 and 180: 16.1 - INTRODUCTION AND FUNCTIONAL
Page 181 and 182: Electronic card top view (see figur
Page 183 and 184: 17.- INCAN OPTION INCAN OPTION TM70
Page 185 and 186: RL4 Pin Name Function + +VI DC powe
Page 187 and 188:
18.1.- INTRODUCTION and FUNCTIONAL
Page 189 and 190:
ANALOGUE OUTPUT The analogue output
Page 191 and 192:
19.1- INTRODUCTION & FUNCTIONAL DES
Page 193 and 194:
OUTPUTS Each analogue output has tw
Page 195 and 196:
TM70Pi V3.2 (11/02) 120021.pdf. 83
Page 197 and 198:
20.1- INTRODUCTION & FUNCTIONAL DES
Page 199 and 200:
OUTPUT 1 (VO1) The connections of t
Page 201 and 202:
20.3- EXPANSIONS POWER SUPPLY ELECT
Page 203 and 204:
21.1 - INTRODUCTION Access to this
Page 205 and 206:
(*) IF PWM FREQ. = 0 (HIGH FREQUENC
Page 207 and 208:
LIMIT VALUES: Set the limits of the
Page 209 and 210:
2.2 - MENU 3.2 RESET VALUES: Restor
Page 211 and 212:
22.1 - MAIN CHARACTERISTICS Softwar
Page 213 and 214:
OPTION 4: List of expansión type a
Page 215 and 216:
22.2 - REMARKS FOR THE INTERNAL WIR
Page 217:
CHINA 北京市朝阳区望京阜
show all

manual de instalação e utilização transmissor console ... - Usicontrol

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?