manual de instalação e utilização transmissor console ... - Usicontrol

9.5 - DATA FEEDBACK OPERATING MODE
The data feedback selection (returned information), can be performed by (a) software or by (b)
hardware (i.e. using a rotatory selector).
(a) Software selection (by default): with the ▲ ―UP‖ and ▼ ―DOWN‖ options, the desire
feedback information can be sequentially selected.
(b) Hardware selection: the remote‘s technical datasheet must include and to identify, the
mechanism that will allow this selection.
Remarks (for multiple returns / multiple feedback):
The transmitter can process multiple feedbacks but only one information can be displayed at the
same time.
There are two possibilities for the multiple feedback:
1) CAN return + one direct input in the receiver.
In this case the receiver must have an analogue electronic card (IN010V or IN0450P) or a digital
electronic card (IN4D) connected to the LR70 card. The INCAN configuration is not allowed in
this case.
In the CAN bus the receiver works as a slave.
2) INCAN electronic board + one direct input in the receiver.
In this case any amount of analogue or digital cards can be connected directly or using the
INCAN expansion card; the CAN return will be disabled.
In the CAN bus the receiver works as a master.
Systems including software revision 2.4.x., will only support the feedback signal directly
connected to the LR70 electronic card. Nevertheless, and due to the INCAN card option the
system will be able to manage several feedback information at the same time with software
revision 3.1.x. or greater.
The user will be able to select the feedback information he wants to show in the LCD70 display.
For this purpose a software or hardware selector will be used. With the software selector and
after pressing the corresponding manoeuvre (Mi) –mechanism or any display function assigned-
, the position of the selector will increase showing the next configured feedback information and
pressing another manoeuvre (Mi) the position will decrease. Thus the selection will be in both
senses. Depending on the position of the selector the transmitter will show a feedback or
another configured one and the display‘s message will change sequentially.
The first feedback will be the information corresponding to the INxxxx card connected directly to
the receiver LR70 board, and then the following INxxxx associated to the INCAN inputs,
depending in the order they are connected, from the lower to the higher position.
Into the EEPROM, and the INCAN file all the parameters will be configured to specify the
LCD70 display feedback edition.
TM70Pi V3.2 (11/02) 120021.pdf. 33
IKUSI reserves the right to change this information without prior notice.