CG RID u&m 02/J-Cop - Operator's Manual

ENG 12 UNPACKING AND ASSEMBLY
Hook all the plastic profiles to the frame
tubes with the help of a screwdriver (7).
Insert the handle (8) into the holes of the
canvas (9). Attach this to the frame using
the screws (10), following the indicated
sequence, and complete the assembly
screwing the four front and rear selfthreading
screws (11).
CLAK
Lastly, fit the stiffening bar (12) on the outside
of the frame base, keeping the flat part towards the canvas and using the
nuts and screws supplied (13) in the sequence indicated.
3 (x 2) 6 (x 4) 10 (x 2) 11 (x 4) 13 (x 2)
7