CG RID u&m 02/J-Cop - Operator's Manual

HOW TO USE THE MACHINE
ENG 27
The circuit automatically resets after a few seconds but the cause of the fault
should be ascertained and dealt with to avoid re-activating the protection device.
IMPORTANT To avoid activating the protection device:
– do not reverse the cables on the battery terminals;
– do not use the machine without its battery or damage may be caused to the
charging regulator;
– be careful to not cause short-circuits.
END OF MOWING
When you have finished mowing, disengage the blade
and ride the machine with the cutting deck in the
highest position.
Stop the machine, engage the parking brake and turn
off the engine by turning the ignition key to «OFF».
When the engine is stopped, close the fuel cock (1).
! WARNING! To avoid backfire, put the accelerator in the «SLOW»
position for 20 seconds before stopping the engine.
! WARNING!
unattended!
5.4 CLEANING AND STORAGE
CLEANING
Always take out the ignition key if leaving the machine
After each mowing, clean the outside of the machine, empty the grass-catcher
and shake it to remove residual grass and earth.
Clean the plastic parts of the body with a damp sponge using water and detergent,
taking care not to wet the engine, the electrical parts or the electronic card
located under the dashboard.
IMPORTANT
body and engine!
Never use hose-nozzles or harsh detergents for cleaning the
1