CG RID u&m 02/J-Cop - Operator's Manual

ENG 14 COMMANDS AND CONTROL INSTRUMENTS
When moving from one area to another, put the lever in a position between
«SLOW» and «FAST» When cutting, go to the «FAST» position.
3. PARKING BRAKE LEVER
This lever is to stop the machine from moving when it has been parked, and must
always be engaged before leaving the machine.
The brake is engaged by fully pressing the pedal (11 - 21) and moving the lever
to position «A». When you take your foot off the pedal it will be blocked by the
lever in the down position.
To disengage the parking brake, press the pedal again so that the lever returns to
position «B».
4. KEY IGNITION SWITCH
This key operated control has three positions:
«OFF» means everything is switched off
«ON» activates all parts
«START» engages the starter motor. On being released, the key
will automatically return to «ON» from this position.
5. PILOT LAMP AND SIGNAL
This light comes on when the key (4) is in the «ON» position and remains constantly
lit while the machine is operating.
When it starts flashing this means that the engine is being prevented from starting
(see 5.3).
The audible warning indicates that the grass-catcher is full (see 5.3).
6. BLADE ENGAGEMENT AND BRAKE LEVER
This lever has two positions, as shown on the label:
Position «A» = BLADE DISENGAGED
Position «B» = BLADE ENGAGED