Modellierung und Validierung der Krafterzeugung mit Stick-Slip ...

LITERATURVERZEICHNIS 185
[140] H. Blok. The dissipation of frictional heat. Applied Scientific Research, 5,
Section A:151–181, 1955.
[141] F. P. Bowden and E. H. Freitag. The friction of solids at very high speeds.
Proceedings of the Royal Society of London. Series A, Mathematical and
Physical, 248 (1254):350–367, 1958.
[142] R. Budakian and S. J. Putterman. Correlation between charge transfer and
stick-slip friction at a metal-insulator interface. Physical Review Letters,
85 (5):1000–1003, 2000.
[143] W. Littmann, H. Storck, and J. Wallaschek. Sliding friction in the presence
of ultrasonic friction: Superposition of longitudinal oscillations. Archive of
Applied Mechanics, 71:549–554, 2001.
[144] C. Edeler, I. Meyer, and S. Fatikow. Modeling of stick-slip micro-drives
(ISSN 1865-3928, Springer). Journal of Micro-Nano Mechatronics, DOI
10.1007/s12213-011-0034-9:1–23, 2011.
[145] M. Lübke. Aufbau eines Reibkraftmessstandes und Durchführung von
Messreihen. Individuelles Projekt Universität Oldenburg, 2010.
[146] Mathworks. Matlab Simulink Toolbox SimMechanics. Adalperostraße 45,
85737 Ismaning, Deutschland, 2011.
[147] SIMPACK AG. SIMPACK general purpose Multi-Body Simulation (MBS)
software. SIMPACK AG (Headquarter), Friedrichshafener Strasse 1, 82205
Gilching, Deutschland, 2011.
[148] J. P. Cleveland, S. Manne, D. Bocek, and P. K. Hansma. A nondestructive
method for determining the spring constant of cantilevers for scanning force
microscopy. Review of Scientific Instruments, 64 (2):403–405, 1993.
[149] N. A. Burnham, X. Chen, C. S. Hodges, G. A. Matei, E. J. Thoreson, C. J.
Roberts, M. C. Davies, and S. J. B. Tendler. Comparison of calibration
methods for atomic-force microscopy cantilevers. Nanotechnology, 14:1–6,
2003.
[150] M. A. Greminger and B. J. Nelson. Vision-Based Force Measurement. IEEE
Transaction on Pattern Analysis and Machine Intelligence, 26 (3):290–298,
2004.