HP iLO 3 Scripting and Command Line Guide - Business Support ...

The iLO firmware maintains consistency between the various places the server name is used. The
host RBSU has a two-line limitation of 14 characters each, or 28 characters of total server name
text length.
Normally, HP ProLiant Management Agents are used to forward the server name attribute to iLO.
This command can be used in instances where management agents are not used. However, the
host operating system remains unaffected.
GET_SERVER_NAME return message
GET_SERVER_NAME returns the currently stored server name, if available. The server name is a
quoted ASCII string and cannot be a network name.
For example:
GET_SERVER_NAME runtime errors
None
SERVER_NAME
The SERVER_NAME command is used to assign the Server Name attribute shown in the user
interface and host RBSU. This setting is not forwarded to the host operating system and does not
affect the host operating system.
You must have the Configure iLO Settings privilege to change this attribute using the scripting
interface. The SERVER_INFO section must be set to WRITE mode or an error is returned.
For example:
SERVER_NAME parameters
VALUE is a quoted ASCII string less than 50 characters in total length.
SERVER_NAME return message
If this attribute is successfully set, no specific message returns.
SERVER_NAME runtime errors
• If the configure iLO settings privilege is absent, a runtime error is returned.
• If SERVER_INFO is not opened for write, a runtime error is returned.
112 RIBCL XML Scripting Language