HP iLO 3 Scripting and Command Line Guide - Business Support ...

GET_HOST_POWER_SAVER_STATUS return messages
The following information is returned within one of the following responses:
•
•
•
•
SET_HOST_POWER_SAVER
The SET_HOST_POWER_SAVER command is used to set the Power Regulator Setting for the server
processor. For this command to parse correctly, the SET_HOST_POWER_SAVER command must
appear within a SERVER_INFO command block, and SERVER_INFO MODE must be set to write.
The user must have the Virtual Power and Reset privilege to execute this command.
For example:
SET_HOST_POWER_SAVER parameters
The HOST_POWER_SAVER command controls the Dynamic Power Saver feature of the server
processor if the feature is supported. The possible values are:
• 1—Operating system control mode
• 2—HP Static Low Power mode
• 3—HP Dynamic Power Savings mode
• 4—HP Static High Performance mode
SET_HOST_POWER_SAVER runtime errors
The possible SET_HOST_POWER error messages include:
• Server information is open for read-only access. Write access is
required for this operation.
• Power Regulator feature is not supported on this server.
• User does not have correct privilege for action. RESET_SERVER_PRIV
required.
GET_HOST_POWER_STATUS
The GET_HOST_POWER_STATUS command requests the power state of the server. For this command
to parse correctly, the GET_HOST_POWER_STATUS command must appear within a SERVER_INFO
command block. You can set SERVER_INFO MODE to read or write.
For example:
124 RIBCL XML Scripting Language