HP iLO 3 Scripting and Command Line Guide - Business Support ...

• To insert a CD-ROM image and set for single boot, enter:
cd /map1/oemhp_vm1/cddr1
set oemhp_image=http://my.imageserver.com/ISO/install_disk1.iso
set oemhp_boot=connect
set oemhp_boot=once
show
This example executes the following commands:
◦ Changes the current context to the CD-ROM drive
◦ Shows the current status to verify that the media is not in use
◦ Inserts the desired image into the drive
◦ Connects the media. The boot setting always connects automatically
◦ Overrides the boot setting to Once
• To eject a CD-ROM image from the virtual CD-ROM in a single command, enter:
set /map1/oemhp_vm1/cddr1 oemhp_boot=disconnect
If you attempt to disconnect when the drive is not connected, you receive an error.
Start and Reset commands
Start and reset commands enable you to power on and reboot the server containing iLO 3 or iLO
3 itself. Table 11 (page 48) shows the Start and Reset command properties.
Table 11 Start and Reset Commands
Command
start
stop
Description
Table 12 Manual Reset Command
Property
manual_iLO_reset
For example
Turns server power on
Turns server power off
Access
Read/Write
Description
The following commands are supported if the current target is:
/system1
• start
• stop
The following commands are supported if the current target is:
/map1
• reset
Allows a delay to iLO resets, which is useful when changing multiple
properties. When enabled, the iLO will reset only when a user logs
out, is disconnected from iLO, or issues a ‘reset/map1’ command.
Set the status of the manual_iLO_reset property using the following commands:
• set /map1/ manual_ilo_reset=yes
• set /map1/ manual_ilo_reset=no
48 SMASH CLP Scripting Language