HP iLO 3 Scripting and Command Line Guide - Business Support ...

Tasks
• To insert a floppy USB key image into the Virtual Floppy/USBKey, enter:
cd /map1/oemhp_vm1/floppydr1
show
set oemhp_image=http://my.imageserver.com/floppyimg.bin
set oemhp_boot=connect
show
This example executes the following commands:
◦ Changes the current context to the floppy or key drive
◦ Shows the current status to verify that the media is not in use
◦ Inserts the desired image into the drive
◦ Connects the media. The boot setting always connects automatically
• To eject a floppy or USB key image from the Virtual Floppy/USBKey, enter:
cd /map1/oemhp_vm1/floppydr1
set oemhp_boot=disconnect
This example executes the following commands:
◦ Changes the current context to the floppy or key drive
◦ Issues the disconnect command that disconnects the media and clears the oemhp_image
• To insert a CD-ROM image into the virtual CD-ROM, enter:
cd /map1/oemhp_vm1/cddr1
show
set oemhp_image=http://my.imageserver.com/ISO/install_disk1.iso
set oemhp_boot=connect
show
This example executes the following commands:
◦ Changes the current context to the CD-ROM drive
◦ Shows the current status to verify that the media is not in use
◦ Inserts the desired image into the drive
◦ Connects the media. The boot setting always connects automatically
• To eject a CD-ROM image from the Virtual CD-ROM, enter:
cd /map1/oemhp_vm1/cddr1
set oemhp_boot=disconnect
This example executes the following commands:
◦ Changes the current context to the CD-ROM drive
◦ Issues the disconnect command that disconnects the media and clears the oemhp_image
Specific commands 47