HP iLO 3 Scripting and Command Line Guide - Business Support ...

• 3—Enabled (records every third authentication failure: this is the default value.)
• 5—Enabled (records every fifth authentication failure)
SERIAL_CLI_STATUS—Specifies the status of the CLI. The possible values include:
• 0—No change
• 1—Disabled
• 2—Enabled (no authentication required)
• 3—Enabled (authentication required)
SERIAL_CLI_SPEED—Specifies the CLI port speed.
NOTE: The serial port speed set using this parameter must match the speed of the serial port set
in the RBSU.
The possible values include:
• 0—No change
• 1—9,600 bps
• 2—19,200 bps
• 3—38,400 bps
• 4—57,600 bps
• 5—115,200 bps
MOD_GLOBAL_SETTINGS runtime errors
Possible MOD_GLOBAL_SETTINGS error messages include:
• RIB information is open for read-only access. Write access is
required for this operation.
• User does not have correct privilege for action. CONFIG_ILO_PRIV
required.
• Unrecognized keyboard model.
BROWNOUT_RECOVERY
The BROWNOUT_RECOVERY command turns the brownout recovery feature on or off. For this
command to parse correctly, it must appear within a RIB_INFO command block, and must appear
within a MOD_GLOBAL_SETTINGS command block. RIB_INFO MODE must be set to write. This
command requires CPQLOCFG.EXE version 4.01 or later. This command requires the iLO 3
firmware version to be v1.25 or later. The user must have the Configure iLO Settings privilege to
execute this command.
For example:
BROWNOUT_RECOVERY parameters
—Disables brownout recovery
84 RIBCL XML Scripting Language