HP iLO 3 Scripting and Command Line Guide - Business Support ...

MOD_NETWORK_SETTINGS runtime errors
Possible MOD_NETWORK_SETTINGS error messages include:
• RIB information is open for read-only access. Write access is
required for this operation.
• User does not have correct privilege for action. CONFIG_ILO_PRIV
required.
• Invalid DNS name, IPv4 address, or IPv6 address. This indicates an invalid
SNTP_SERVERx value address or FQDN string.
• Invalid IPv6 Address. This indicates an invalid IPv6 address and/or prefix length was
entered.
• Duplicate IPv6 Address. An address was duplicated in the script, or also possibly an
address specified in the script is already in use by iLO.
• IPv6 Addresses and Static Routes are in conflict. Indicates you tried to use
an address prefix as a static route destination when it is already in use for a static address.
Static addresses are assumed to be on-link by default, and therefore cannot also require
routing.
MOD_NETWORK_SETTINGS parameters
If the following parameters are not specified, then the parameter value for the specified setting is
preserved. Zero values are not permitted in some fields. Consequently, an empty string deletes the
current value in some fields.
ENABLE_NIC enables the NIC to reflect the state of iLO. The values are Yes or No. It is case
insensitive.
SHARED_NETWORK_PORT sets the Shared Network Port value. The values are Yes or No. For
iLO, the Shared Network Port feature is only available on servers with hardware, NIC firmware,
and iLO firmware that supports this feature. For iLO, the Shared Network Port is supported on all
firmware versions, and the feature is available if the hardware is supported. This command is
supported on all 300, 500, and 700 ML/DL servers.
When using the iLO Shared Network Port, flashing the iLO firmware through the XML interface
takes approximately 7 minutes to complete. Flashing the firmware using Shared Network Port with
iLO does not take any longer to complete than using the dedicated iLO management port.
SHARED_NETWORK_PORT_VLAN VALUE enables iLO 3 Shared Network Port VLAN ID tagging.
The possible values are Yes or No
SHARED_NETWORK_PORT_VLAN_ID VALUE sets the VLAN ID value. Values must be between 1
and 4094.
REG_DDNS_SERVER VALUE instructs iLO to register the management port with a DDNS server.
The possible values are Yes or No.
SPEED_AUTOSELECT is a Boolean parameter to enable or disable the iLO transceiver to auto-detect
the speed and duplex of the network. This parameter is optional, and the Boolean string must be
set to Yes if this behavior is desired. If this parameter is used, the Boolean string value must not
be left blank. The possible values are Yes or No. It is case insensitive.
FULL_DUPLEX is used to decide if iLO is to support full-duplex or half-duplex mode. It is only
applicable if SPEED_AUTOSELECT was set to No. The possible values are Yes or No. It is case
insensitive.
NIC_SPEED is used to set the transceiver speed if SPEED_AUTOSELECT was set to No. The possible
values are 10 or 100. Any other values result in a syntax error.
DHCP_ENABLE is used to enable DHCP. The possible values are Yes or No. It is case insensitive.
78 RIBCL XML Scripting Language