HP iLO 3 Scripting and Command Line Guide - Business Support ...
HP iLO 3 Scripting and Command Line Guide - Business Support ...
HP iLO 3 Scripting and Command Line Guide - Business Support ...
Erfolgreiche ePaper selbst erstellen
Machen Sie aus Ihren PDF Publikationen ein blätterbares Flipbook mit unserer einzigartigen Google optimierten e-Paper Software.
delete Removes instances of the MAP in the name space.<br />
load Moves a binary image from a URL to the MAP.<br />
reset Causes a target to cycle from enabled to disabled, <strong>and</strong> back to enabled.<br />
set Sets a property or set of properties to a specific value, <strong>and</strong> resets <strong>iLO</strong> to<br />
implement the changes.<br />
start Causes a target to change the state to a higher run level.<br />
stop Causes a target to change the state to a lower run level.<br />
version The comm<strong>and</strong> queries the version of the CLP implementation or other CLP<br />
elements.<br />
For example:<br />
hp<strong>iLO</strong>-> version<br />
status=0<br />
status_tag=COMMAND COMPLETED<br />
SM-CLP Version 1.0<br />
oemhp_ping The comm<strong>and</strong> determines if an IP address is reachable from the current<br />
<strong>iLO</strong> session.<br />
Specific comm<strong>and</strong>s<br />
For example:<br />
oemhp_ping 192.168.1.1<br />
Where 192.168.1.1 is the IP address you are testing.<br />
The following sections cover <strong>iLO</strong> 3-specific comm<strong>and</strong>s available when using the comm<strong>and</strong> line,<br />
including:<br />
• “User comm<strong>and</strong>s” (page 34)<br />
• “<strong>HP</strong> SIM SSO settings” (page 34)<br />
• “Network comm<strong>and</strong>s” (page 36)<br />
• “<strong>iLO</strong> 3 settings” (page 39)<br />
• “<strong>iLO</strong> 3 embedded health settings” (page 41)<br />
• “SNMP settings” (page 43)<br />
• “License comm<strong>and</strong>s” (page 44)<br />
• “Directory comm<strong>and</strong>s” (page 44)<br />
• “Virtual Media comm<strong>and</strong>s” (page 45)<br />
• “Start <strong>and</strong> Reset comm<strong>and</strong>s” (page 48)<br />
• “Firmware update” (page 49)<br />
• “Eventlog comm<strong>and</strong>s” (page 49)<br />
• “Blade comm<strong>and</strong>s” (page 50)<br />
• “Boot comm<strong>and</strong>s” (page 50)<br />
• “LED comm<strong>and</strong>s” (page 51)<br />
• “System properties <strong>and</strong> targets” (page 52)<br />
• “Other comm<strong>and</strong>s” (page 55)<br />
Specific comm<strong>and</strong>s 33