HP iLO 3 Scripting and Command Line Guide - Business Support ...

MOD_SNMP_IM_SETTINGS parameters
All of the following parameters are optional. If a parameter is not specified, then the parameter
value for the specified setting is preserved.
SNMP_ADDRESS_1, SNMP_ADDRESS_2, and SNMP_ADDRESS_3 are the addresses that receive
traps sent to the user. Each of these parameters can be any valid IP address.
OS_TRAPS determines if the user is allowed to receive SNMP traps that are generated by the
operating system. The possible values are Yes and No. By default, the value is set to No.
RIB_TRAPS determines if the user is allowed to receive SNMP traps that are generated by the RIB.
The possible values are Yes and No. By default, the value is set to No.
WEB_AGENT_IP_ADDRESS is the address for the Web-enabled agents. The value for this element
has a maximum length of 50 characters. It can be any valid IP address. If an empty string is entered,
the current value is deleted.
SNMP_PASSTHROUGH_STATUS determines if iLO can receive and send SNMP requests to and
from the host OS. By default, the value is set to Yes.
CIM_SECURITY_MASK accepts an integer between 0 and 4. The possible values are:
• 0—No change
• 1—None (no data is returned)
• 2—Low (name and status data are returned. Associations are present if SNMP pass-through
is supported. If not, the server and management processor are separate entities in the device
list.)
• 3—Medium (iLO and server associations are present but the summary page contains less
detail than at high security)
• 4—High (associations are present and all data is present on the summary page)
Each value indicates the level of data returned over the HTTP port.
MOD_SNMP_IM_SETTINGS runtime errors
Possible MOD_SNMP_IM_SETTINGS error messages include:
• RIB information is open for read-only access. Write access is
required for this operation.
• User does not have correct privilege for action. CONFIG_ILO_PRIV
required.
UPDATE_FIRMWARE
The UPDATE_FIRMWARE command copies a specified file to iLO, starts the upgrade process, and
reboots the board after the image has been successfully flashed. For this command to parse correctly,
the command must appear within a RIB_INFO command block, and RIB_INFO MODE must be set
to write. The user must have the Configure iLO Settings privilege to execute this command.
Example 1:
86 RIBCL XML Scripting Language