HP iLO 3 Scripting and Command Line Guide - Business Support ...

The following Boot commands set the boot source for the system. Possible values are:
• BootFmCd : bootsource1
• BootFmFloppy : bootsource2
• BootFmDrive : bootsource3
• BootFmUSBKey : bootsource4
• BootFmNetwork : bootsource5
Table 17 Boot Command Properties
Property
bootorder
For example
Access
Read/write
Description
Sets the boot order for a given boot source
• set /system1/bootconfig1/bootsource(n) bootorder=(num)
• show /system/bootconfig1—Displays the complete boot configuration
• show /system1/bootconfig1/bootsource1—Displays boot order for bootsource1.
LED commands
LED commands are used to change the state of the UID light on the server. Table 18 (page 51)
shows the LED command properties. LED settings are available at:
/system1/led1
Table 18 LED Command Properties
Property
start
stop
show
For example
Description
Turns the LED on.
Turns the LED off.
Displays the LED status.
• show /system1/led1—Displays current LED status
• start /system1/led1—Turns LED on
• stop /system1/led1—Turns LED off
iLO 3 CLI support
Simple UID CLI commands are supported:
• uid—Displays the current UID state on the server.
• uid on—Turns the UID light on.
• uid off—Turns the UID light off.
The CLP format is supported as well:
• show /system1/led1—Verifies LED status
• start /system1/led1—Turns LED on
• stop /system1/led1—Turns LED off
Specific commands 51