HP iLO 3 Scripting and Command Line Guide - Business Support ...

Example output:
/system1/oemhp_power1
Targets
Properties
oemhp_powerreg=os
oemhp_pwrcap=0 Watts
oemhp_PresentPower=147 Watts
oemhp_AvgPower=146 Watts
oemhp_MaxPower=180 Watts
oemhp_MinPower=146 Watts
oemhp_powersupplycapacity=750 Watts
oemhp_servermaxpower=361 Watts
oemhp_serverminpower=144 Watts
warning_type=disabled
warning_threshold=750 Watts
warning_duration=240 Minutes
oemhp_power_micro_ver=1.6
oemhp_auto_pwr=OFF
The following properties are available in:
/system1
Table 20 System Properties
Property
name
number
oemhp_server_name
enabledstate
processor_number
For example
• show /system1
Access
Read
Read
Read
Read
Read
• show /system1 name
Description
• set /system1 oemhp_powerreg=auto
Displays the system name.
Displays the system serial number.
Displays the host server name string. This string can be up to 50
characters in length, and requires the Configure iLO Settings privilege
to change.
Appears if the server is powered up.
Displays the number of logical processors in the system.
The CPU property is a target of /system1 and displays information about the system processor.
Table 21 (page 53) shows the System CPU properties. The properties are available at:
/system1/cpun
Where n is the processor number.
Table 21 System CPU Properties
Property
number_cores
active_cores
threads
speed
memory_technology
cachememory1
Access
Read
Read
Read
Read
Read
Read
Description
Displays the number of processor cores.
Displays the number of active processor cores.
Displays the total number of threads on the active processor cores.
Displays the processor speed.
Displays the bit level technology of the memory.
Displays the size of the processor level-1 cache.
Specific commands 53