HP iLO 3 Scripting and Command Line Guide - Business Support ...

PWRALERT_SETTINGS
• THRESHOLD — Sets the alert threshold, in watts.
• DURATION — Sets the length of the sample time, in minutes, starting at 5. Duration will always
be in 5 minute intervals up to 240 minutes maximum. Any positive integer can be used, but
it will be rounded off to the nearest 5.
SET_PWREG runtime errors
Possible SET_PWREG error messages include:
• Server information is open for read-only access. Write access is
required for this operation.
• Internal error.
• The value specified is invalid.
• This feature requires an installed license key.
• User does NOT have correct privilege for action. CONFIG_ILO_PRIV
required.
• The PWRALERT value is invalid.
• The THRESHOLD value is invalid.
• The DURATION value is invalid. Values supported are between 1 and
240.
• Invalid integer.
GET_POWER_CAP
The GET_POWER_CAP command is used to get the power cap of the server. For this command
to parse correctly, the GET_POWER_CAP command must appear within a SERVER_INFO command
block, and SERVER_INFO MODE can be set to read. You must purchase the iLO Advanced license
to enable this feature.
For example:
GET_POWER_CAP parameters
None
GET_POWER_CAP return messages
A cap value of zero indicates a power cap is not currently set on the server.
SET_POWER_CAP
The SET_POWER_CAP command is used to set a power cap on the server. For this command to
parse correctly, the SET_POWER_CAP command must appear within a SERVER_INFO command
block, and SERVER_INFO MODE must be set to write. You must have the Configure iLO Settings
privilege to execute this command.
122 RIBCL XML Scripting Language