HP iLO 3 Scripting and Command Line Guide - Business Support ...

Table 9 Virtual Media Command Targets
Target
/map1/oemhp_vm1/floppydr1
/map1/oemhp_vm1/cddr1
Description
Virtual floppy or key drive device
Virtual CD-ROM device
Table 10 Virtual Media Command Properties
Property
oemhp_image
oemhp_connect
oemhp_boot
oemhp_wp
Image URL
Access
Read/Write
Read
Read/Write
Read/Write
Description
The image path and name for virtual media access. The value is a URL with a
maximum length of 80 characters.
Displays if a virtual media device is already connected through the CLP or
scriptable virtual media.
Sets the boot flag. The valid values are:
• Never
Do not boot from the device. The value appears as No_Boot.
• Once
Boot from the device only once. The value appears as Once.
• Always
Boot from the device each time the server is rebooted. The value is displayed
as Always.
• Connect
Connect the virtual media device. Sets oemhp_connect to Yes and
oemhp_boot to Always.
• Disconnect
Disconnects the virtual media device and sets the oemhp_boot to No_Boot.
Enables or disables the write-protect flag. Boolean values accepted.
The oemhp image value is a URL. The URL, which is limited to 80 characters, specifies the location
of the virtual media image file on an HTTP server and is in the same format as the scriptable virtual
media image location.
URL example:
protocol://username:password@hostname:port/filename
• protocol—Mandatory field that must be HTTP or HTTPS
• username:password—Optional field
• hostname—Mandatory field
• port—Optional field
• filename—Mandatory field
The CLP performs only a cursory syntax verification of the URL value. You must visually verify that
the URL is valid.
For example
• set oemhp_image=http://imgserver.company.com/image/dosboot.bin
• set oemhp_image=http://john:abc123@imgserver.company.com/VMimage/
installDisk.iso
46 SMASH CLP Scripting Language