HP iLO 3 Scripting and Command Line Guide - Business Support ...

As of release iLO 3 version 1.05, the Virtual Serial Port supports automatically enabling and
disabling software flow control. By default, this behavior is disabled. You can enable this
configuration option using the RIBCL only. To enable this option, execute the following script:
Example:
The VSP_SOFTWARE_FLOW_CONTROL feature is not supported in iLO 3.
MOD_GLOBAL_SETTINGS parameters
The following parameters are optional. If you do not specify a parameter, then the parameter value
for the specified setting is preserved.
NOTE: If any port changes are detected, iLO reboots to apply the changes after the script has
completed successfully.
SSH_STATUS—Determines if SSH is enabled. The valid values are Yes or No, which enable or
disable SSH functionality.
SSH_PORT—Specifies the port used for SSH connection on iLO 3. The processor must be reset if
this value is changed.
REMOTE_CONSOLE_PORT—Specifies the port used for remote console.
HTTP_PORT—Specifies the HTTP port number.
HTTPS_PORT—Specifies the HTTPS (SSL) port number.
VIRTUAL_MEDIA_PORT—Specifies the port used for virtual media.
SESSION_TIMEOUT—Determines the maximum session timeout value in minutes. The accepted
values are 0, 15, 30, 60, and 120. A value of 0 specifies infinite timeout.
ILO_FUNCT_ENABLED—Determines if the Lights-Out functionality is enabled or disabled for iLO.
The possible values are Yes or No. This parameter is case insensitive.
F8_PROMPT_ENABLED—Determines if the F8 prompt for ROM-based configuration appears during
POST. The possible values are Yes or No.
F8_LOGIN_REQUIRED—Determines if login credentials are required to access the RBSU for iLO.
The possible values are Yes or No.
MIN_PASSWORD—Specifies how many characters are required in all user passwords. The value
can be from zero to 39 characters.
ENFORCE_AES—Determines if iLO enforces the use of AES/3DES encryption ciphers over the iLO
interface, SSH, and XML connections. The possible values are Yes or No.
AUTHENTICATION_FAILURE_LOGGING—Specifies logging criteria for failed authentications.
Possible values include:
• 0—Disabled
• 1—Enabled (records every authentication failure)
• 2—Enabled (records every second authentication failure)
RIB_INFO 83