GENERAL CATALOGUE - Mapei

150
18. PRODUCTS FOR ANCHORING AND RAPID FIXING
Lampocem
Ready-to-use, quick-setting and
hardening, anti-shrinkage hydraulic
binder.
Mapefill
Fluid expansive mortar for anchoring
objects in place.
Mapefill R
Quick-hardening, fluid expansive mortar
for quickly anchoring objects in place.
Mapefix EP
Pure epoxy resin chemical
fastener for structural loads.
EN 1504-6
IN COMPLIANCE WITH
EUROPEAN STANDARD
EN 1504-6
ANCHORING MORTAR
EN 1504-6
IN COMPLIANCE WITH
EUROPEAN STANDARD
EN 1504-6
ANCHORING MORTAR
European Technical Approval
option 1 for cracked concrete
European Technical Approval
option 7 for non cracked concrete
TECHNICAL DATA:
Maximum dimension of aggregate: < 0.1 mm.
Mixing ratio: 100 parts of LAMPOCEM with
20-21 parts of water.
Pot life of mix: approximately 1 minute (at +23°C).
Storage: 12 months.
Application: trowel or gauging trowel.
Consumption: 1.8 kg/dm³ of cavities to be filled.
Packaging: 25 kg bags, boxes of 4x5 kg packets,
packages of 4x5 kg cartridges and packages of
9x1 kg cartridges.
TECHNICAL DATA:
Maximum dimension of aggregate: 2.5 mm.
Mixing ratio: 100 parts of MAPEFILL with 14-15 parts
of water.
Pot life of mix: approximately 1 hour (at +20°C).
Maximum applicable thickness: 6 cm per layer.
Classification: EN 1504-6.
Storage: 12 months.
Application: pouring.
Consumption: 1.95 kg/m³ of cavities to be filled.
Packaging: 25 kg vacuum-packed polyethylene bags.
TECHNICAL DATA:
Maximum dimension of aggregate: 2.5 mm.
Mixing ratio: 100 parts of MAPEFILL R with
17-18 parts of water.
Pot life of mix: approximately 45 minutes (at +20°C).
Maximum applicable thickness: 6 cm per layer.
Classification: EN 1504-6.
Storage: 12 months.
Application: pouring.
Consumption: 1.95 kg/m³ of cavities to be filled.
Packaging: 25 kg vacuum-packed polyethylene bags.
TECHNICAL DATA:
Suitable substrates: all full and perforated substrates,
such as concrete and concrete derivates, brickwork,
mixed masonry, wood and rock.
Recommended perforation technique: drill, hammer
drill, core drilling, diamond-tipped tools.
Condition of hole for application: clean; dry or damp
or wet.
Workability time at +20°C: 30’.
Final hardening time at +20°C: 10 h (dry substrate),
20 h (wet substrate).
Recommended diameter of fastener: from M8 to M39,
from φ8 to φ40.
Certification available: CE mark; ETA option 7
(fasteners in compressive side); ETA option 1
(fasteners in tensile side); reaction to fire.
Application: extrusion gun.
Packaging: 385 ml.