Enabler-G AT Command Set - SE Spezial-Electronic AG

AT Command Set Reference
Version 1.08
3.2.9.2. $EVTIM# User Defined Input Event # =
(continued)
Example:
These commands will cause the example in AT$EVENT to trigger every 60
seconds.
AT$EVENT=1,1,12,1,1
AT$EVTIM1=60
Ending range of 1 (high)
Starting range of 1 (high)
Activate event timer 1
Input event
Event group 1
** Please note that you will have to toggle the I/O pin # 2 low with the
AT$IOGP2=0 command prior to each event time cycle to see the I/O line
go high based on the timer. In this example, prior to each 60 second time
cycle.
GSM0107PB001MAN Page 275 of 370 1.08 – 25 January 2007