magicolor 1650EN User's Guide - Konica Minolta

8-22
Symptom Cause Solution
Printing
takes too
much time.
Blank pages
are printed.
Printer
returned to
IDLE before
the configuration
menu
was
changed.
Not all pages
print.
The printer is set to a
slow printing mode
(for example, thick
stock).
The printer is set to
power saving mode.
The job is very complex.
A toner cartridge for a
different region is
installed (X INCOR-
RECT is displayed in
the message window).
One or more of the
toner cartridges are
defective or empty.
The wrong media is
being used.
The printer was in the
configuration menu
structure without a
selection being made
within two minutes.
The Cancel key was
pressed.
It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
It takes time for printing to start in
power saving mode.
Wait. No action needed.
Install a correct KONICA MINOLTA
toner cartridge approved for your specific
printer.
Check the toner cartridges. The image
will not print correctly or not at all, if a
cartridge is empty.
Check that the media type set in the
driver matches the media loaded in the
printer.
When in the configuration menu structure,
select your choice within 2 minutes.
Make sure no one pressed the Cancel
key while your job was printing.
The tray is empty. Check that the tray is loaded with
media, in place, and secure.
A document is printed
with an overlay file
which has been created
by a non-suitable
driver.
Print the overlay file using a suitable
driver.
Solving Other Problems