magicolor 1650EN User's Guide - Konica Minolta

More documents

Recommendations

Info

INTERFACE MENU With this menu, interface settings can be specified. The printer must be rebooted after any setting in the ETHERNET menu (for example, the TCP/IP address) is changed. Therefore, the following message appears when the configuration menu is exited (the + key is repeatedly pressed) after a setting has been changed. Select YES, and then press the Menu Select key to reboot the printer. Otherwise, turn off the printer, and then turn the printer on again after a few seconds. INTERFACE MENU ETHERNET * TCP/IP ENABLE IP SERVICES IPV4 DHCP/BOOTP IPV4 ADDRESS DEFAULT ROUTER SUBNET MASK ENABLE AUTO IP ENABLE Configuration Menu Overview 4-17 IPV6 ENABLE HTTP IDENTIFIER
4-18 USB IPX/SPX ETHERNET SPEED DISABLE 802.1X PS PROTOCOL ENABLE JOB TIMEOUT DISABLE FILTERS DISABLE IPSEC FRAME TYPE ENABLE AUTO GLOBAL PREFIX * If MAIN MENU/SYSTEM DEFAULT/SECURITY/CONFIG/ ENABLE is set to ON, the administrator password must be entered to display this menu. For details on the default administrator password, refer to “SYSTEM DEFAULT” on page 4-22. Configuration Menu Overview
Page 1 and 2:
magicolor 1650EN User’s Guide A03
Page 3 and 4:
x-2 SOFTWARE LICENSE AGREEMENT This
Page 5 and 6: 4. DISCLAIMER OF WARRANTY Adobe lic
Page 7 and 8: 5. All company names and product na
Page 9 and 10: x-8 this License Agreement will rem
Page 11 and 12: 2 Using the Printer Driver ........
Page 13 and 14: x-12 Cleaning the Print Head Window
Page 15 and 16: Getting Acquainted with Your Printe
Page 17 and 18: 1-4 Printer Parts 11 The following
Page 19 and 20: 1-6 Front View with Options (when T
Page 21 and 22: Printer Driver CD/DVD 1-8 PostScrip
Page 23 and 24: 1-10 Documentation Documentation Us
Page 25 and 26: 1-12 System Requirements
Page 27 and 28: Selecting Driver Options/Defaults (
Page 29 and 30: Uninstalling the Printer Driver (fo
Page 31 and 32: Using the Postscript and PCL Printe
Page 33 and 34: 2-8 Basic Tab The Basic Tab allows
Page 35 and 36: 2-10 Select that the white backgro
Page 37 and 38: Working with the Status Monitor 3-2
Page 39 and 40: 3-4 Closing the Status Monitor
Page 41 and 42: About the Control Panel 4-2 The con
Page 43 and 44: 4-4 Toner Supply Indicators The ind
Page 45 and 46: 4-6 MAIN MENU PRINT MENU With this
Page 47 and 48: 4-8 PAPER MENU With this menu, the
Page 49 and 50: 4-10 CUSTOM SIZE WIDTH (xx) LENGTH
Page 51 and 52: 4-12 PAGE RECOV- ERY Settings ON/OF
Page 53 and 54: 4-14 All factory default values ar
Page 55: 4-16 DUPLEX SPEED Settings AUTOMATI
Page 59 and 60: 4-20 IP SER- VICES ENABLE AUTO IP S
Page 61 and 62: 4-22 SYSTEM DEFAULT With this menu,
Page 63 and 64: 4-24 EMULA- TIONS DEFAULT Settings
Page 65 and 66: 4-26 FORMAT ERASE FLASH RESTORE /SA
Page 67 and 68: 4-28 Configuration Menu Overview
Page 69 and 70: Print Media Specifications Media Me
Page 71 and 72: 5-4 Keep media between 15% and 85%
Page 73 and 74: 5-6 Labels A sheet of labels consis
Page 75 and 76: 5-8 Use postcards that are Approve
Page 77 and 78: Loading Media How do I load media?
Page 79 and 80: 5-12 4 Slide the media guides again
Page 81 and 82: 5-14 4 Load the envelopes flap side
Page 83 and 84: 5-16 Loading Labels/Postcard/Thick
Page 85 and 86: 5-18 Tray 2 Only Letter/A4 plain pa
Page 87 and 88: 5-20 7 Reinsert Tray 2 into the pri
Page 89 and 90: 5-22 In addition, if “N-up” has
Page 91 and 92: 5-24 Media Storage
Page 93 and 94: Replacing Consumables 6-2 Note Fail
Page 95 and 96: 6-4 Keep toner cartridges: In thei
Page 97 and 98: 6-6 Press Key Until Display Reads
Page 99 and 100: 6-8 Note Do not touch the contact i
Page 101 and 102: 6-10 Note Do not touch the contact
Page 103 and 104: 6-12 Removing All Toner Cartridges
Page 105 and 106: 6-14 3 Pull down the handle on the
Page 107 and 108:
6-16 Replacing the Imaging Cartridg
Page 109 and 110:
6-18 5 Carefully close the top cove
Page 111 and 112:
6-20 3 Push the blue handles back a
Page 113 and 114:
6-22 7 Remove the fuser separator m
Page 115 and 116:
6-24 9 After the fuser unit is firm
Page 117 and 118:
Maintaining the Printer 7-2 CAUTION
Page 119 and 120:
Cleaning the Printer 7-4 CAUTION Be
Page 121 and 122:
7-6 Note Do not touch the PC drum a
Page 123 and 124:
7-8 4 Slowly insert the imaging car
Page 125 and 126:
7-10 To exit P/H CLEAN UP mode, pr
Page 127 and 128:
7-12 6 Grab the handle and lift it
Page 129 and 130:
7-14 Note Decreased print quality m
Page 131 and 132:
7-16 11 Align the shaft on each end
Page 133 and 134:
7-18 Cleaning the Media Feed Roller
Page 135 and 136:
7-20 Cleaning the Media Feed Roller
Page 137 and 138:
7-22 Cleaning the Duplex Feed Rolle
Page 139 and 140:
Introduction 8-2 This chapter provi
Page 141 and 142:
Preventing Media Misfeeds 8-4 Make
Page 143 and 144:
8-6 Media Misfeed Messages and Clea
Page 145 and 146:
8-8 Note Do not touch the PC drum a
Page 147 and 148:
8-10 4 Remove any misfed media. If
Page 149 and 150:
8-12 5 Return the fuser separator l
Page 151 and 152:
8-14 Clearing a Media Misfeed From
Page 153 and 154:
8-16 8 Reinsert Tray 2. 9 Open and
Page 155 and 156:
8-18 3 Close the duplex cover. Clea
Page 157 and 158:
8-20 Symptom Cause Solution Media i
Page 159 and 160:
8-22 Symptom Cause Solution Printin
Page 161 and 162:
8-24 Symptom Cause Solution Media i
Page 163 and 164:
8-26 Symptom Cause Solution Image i
Page 165 and 166:
8-28 Symptom Cause Solution There a
Page 167 and 168:
8-30 Symptom Cause Solution Colors
Page 169 and 170:
8-32 This message... means... do th
Page 171 and 172:
8-34 Error Messages (Operator Call)
Page 173 and 174:
8-36 Service Messages These message
Page 175 and 176:
Introduction 9-2 Note Use of access
Page 177 and 178:
9-4 2 Remove the dust cover from Tr
Page 179 and 180:
Duplex Option 9-6 Duplex (Double Si
Page 181 and 182:
9-8 Installing the Duplex Option T
Page 183 and 184:
9-10 6 Reconnect all interface cabl
Page 185 and 186:
Technical Specifications A-2 Printe
Page 187 and 188:
A-4 Acoustic Noise Printing: 50 dB
Page 189 and 190:
Our Concern for Environmental Prote
Page 191:
Interior ..........................
show all

magicolor 1650EN User's Guide - Konica Minolta

Create successful ePaper yourself

Delete template?

Save as template?