magicolor 1650EN User's Guide - Konica Minolta

DO NOT use thick stock that is
Mixed with any other media in Tray 1 (as this will cause printer misfeeding)
Envelopes
Print on the front (address) side only. Some parts of the envelope consist of
three layers of paper—the front, back, and flap. Anything printed in these layered
regions may be lost or faded.
Capacity Tray 1 Up to 10 envelopes, depending on their
thickness
Tray 2 Not supported
Orientation Face up
Driver
Media Type
Envelope
Duplexing Not supported
Use envelopes that are
Envelope C6 or Envelope DL
(Other envelope sizes are not supported.)
Common office envelopes approved for laser printing with diagonal joints,
sharp folds and edges, and ordinary gummed flaps
Because the envelopes pass through heated rollers, the gummed
area on the flaps may seal. Using envelopes with emulsion-based
glue avoids this problem.
Approved for laser printing
Dry
DO NOT use envelopes that have
Sticky flaps
Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for sealing
Transparent windows
Too rough of a surface
Material that will melt, vaporize, offset, discolor, or emit dangerous fumes
Been presealed
Media Types 5-5