Dosimetrist/Physicist Training Guide - UCSF Radiation Oncology

More documents

Recommendations

Info

MOSAIQ Dosimetrist/Physicist Training Guide Module I Notes Copying Simulation Field into Treatment Fields You copy simulation field to add new treatment fields directly. When you copy the simulation field, you can: • Add field data and treatment field notes • Add parameters for accessories such as wedges, compensators, and blocks • Change any geometric settings copied from the simulation field In the following exercises, you will copy a simulation field and add treatment field data, add geometric and accessory settings, add a treatment field note, and apply the tolerance table. Copying Simulation Fields and Adding Treatment Field Data In this exercise, you will copy a simulation field and add header, beam, and portal image information. 1. In the Diagnoses and Interventions window, click the 1 - Lt. AP Lung simulation field, then click . Opens the Confirm Field Copy message box. 2. Click . Opens the Machine Characterization warning message box, shown in Figure 72. Figure 72: Machine Characterization Warning Message Box 3. Click . The Machine Characterization warning does not appear each time before the Treatment Field Definition dialog box opens. Opens the Treatment Field Definition dialog box, shown in Figure 73. If your default settings cause the Field Setup view to appear, click to open the Tx Field view. 92 Copyright 2009, IMPAC Medical Systems LTGRAD0005A/2.0/26-Feb-2009
Notes Lesson 3: Adding Simulation and Treatment Fields Copyright 2009, IMPAC Medical Systems 93 LTGRAD0005A/2.0/26-Feb-2009 Beam settings not available to a Simulation field Accessories settings not available to a Simulation field Figure 73: Treatment Field Definition Dialog Box The Treatment Field Definition dialog box contains the header information and geometric parameters from the copied simulation field. It also has fields to configure the dose. You must, at minimum, complete the Type and Modality fields and apply a tolerance table. 4. Click Static from the Type field. Specifies the type of beam. Geometric settings 5. Click Xrays from the Modality field. Field setup note or field graphic Couch settings Portal Image settings not available to a Simulation field Opens the Beam Configurations dialog box, shown in Figure 74. Figure 74: Beam Configurations Dialog Box
Page 1:
MOSAIQ Dosimetrist/Physicist Traini
Page 4 and 5:
PUBLISHED BY: IMPAC Medical Systems
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51: MOSAIQ Dosimetrist/Physicist Traini
Page 140 and 141: Check tasks covered Can you do the
show all

Dosimetrist/Physicist Training Guide - UCSF Radiation Oncology

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?