SUSE LINUX Documentation - Index of

46 Start-Up
satisfied with the settings, click OK to return to the module and Finish to complete
configuration.
If you have a USB device, this configuration is not necessary. Plug in the joystick and
start using it.
2.4.9 Keyboard Layout
To configure the keyboard for the console, run YaST in text mode then use Hardware
→ Keyboard Layout. After clicking the module, the current layout is displayed. To
choose another keyboard layout, select the desired layout from the list provided. Test
the layout in Test by pressing keys on the keyboard.
Fine-tune the settings by clicking Expert Settings. You can adjust the key repeat rate
and delay and configure the start-up state by choosing the desired settings in Start-Up
States. For Devices to Lock, enter a space-separated list of devices to which to apply
the Scroll Lock , Num Lock , and Caps Lock settings. Click OK to complete the fine-tuning.
Finally, after all selections have been made, click Accept for your changes to take effect.
To set up the keyboard for the graphical environment, run the graphical YaST then select
Keyboard Layout. Find information about the graphical configuration in Section 2.13.3,
“Keyboard Properties” (page 84).
2.4.10 Mouse Model
When configuring the mouse for the graphical environment, click Mouse Model to access
the SaX2 mouse configuration. Refer to Section 2.13.2, “Mouse Properties” (page 83)
for details.
To configure your mouse for the text environment, use YaST in text mode. After entering
text mode and selecting Hardware → Mouse Model, use the keyboard arrow keys to
choose your mouse from the provided list. Then click Accept to save the settings and
exit the module.