CommandCenter Secure Gateway - Admin Guide - Version ... - Raritan

Chapter 8: Nodes, Node Groups, and Interfaces
4. Type a description of this interface in the Description field. Optional.
5. Click OK to save your changes.
Interfaces for DRAC, RSA, and ILO Processor Power Control Connections
To add an interface for DRAC, RSA, and ILO Processor power
control connections:
1. Type the IP Address or Hostname for this interface in the IP
Address/Hostname field.
2. Type a TCP Port for this connection in the TCP Port field. Optional.
3. Enter authentication information:
• To use a service account for authentication, select the Use Service
Account Credentials checkbox. Select the service account to use
in the Service Account Name menu.
or
• Enter a Username and Password for authentication.
4. Type a description of this interface in the Description field. Optional.
5. Click OK to save your changes.
Interfaces for Managed Powerstrip Connections
When you create a Managed Power Strip interface that specifies a KX as
the managing device, the outlet you specify will be renamed with the
associated node's name.
To add an interface for managed powerstrip connections:
1. Managing Device:
• Select the Raritan device to which the Power Strip is connected.
The device must be added to CC-SG.
or
• Select Dominion PX if this power control interface uses a PX
device on the IP network that is not connected to another Raritan
device.
2. Managing Port: select the port on the Raritan device to which the
Power Strip is connected. This field is disabled when you select PX as
the Managing Device.
3. Power Strip Name: select the Power Strip or PX device that provides
power to the node. The power strip or PX device must be configured in
CC-SG before it appears in this list.
4. Outlet Name: select the name of the outlet the node is plugged into.
Optional.
96