CommandCenter Secure Gateway - Admin Guide - Version ... - Raritan

Chapter 6: Devices, Device Groups, and Ports
Delete a Blade Chassis Device
You can delete a blade chassis device connected to a KX2 device from
CC-SG. When you delete the blade chassis device from the KX2 device,
the blade chassis device and all configured blade servers or slots
disappear from the Devices tab as well as from the Nodes tab.
To delete a blade chassis device:
1. Click the Devices tab and select a KX2 device whose blade chassis
device you want to delete.
2. Choose Devices > Port Manager > Delete Ports.
3. Select the checkbox of the blade chassis port you want to delete.
4. Click OK to delete the selected blade chassis port. A message
appears asking you to confirm the deletion of the blade chassis device
along with all of its blade servers.
Move a Blade Chassis Device to a Different Port
When physically moving a blade chassis device from one KX2 device or
port to another KX2 device or port, CC-SG cannot detect and
automatically update the configuration data of the blade chassis device to
the new port. You must configure the blade chassis device on CC-SG
once again.
To move a blade chassis device to a different KX2 device or port:
1. Delete the blade chassis device from CC-SG. See Delete a Blade
Chassis Device (on page 46).
2. Disconnect and reconnect the blade chassis to another KX2 device or
port.
3. Add the blade chassis device in CC-SG. See Add a Blade Chassis
Device (on page 42).
Restore Blade Servers Ports to Normal KX2 Ports
This section applies only to the blade chassis without an integrated
KVM switch, such as HP BladeSystem series.
You may re-configure blade servers beneath the virtual blade chassis as
normal KX2 ports in the Devices tab.
To restore blade servers to normal KX2 ports:
1. In the Devices tab, select the KX2 device whose blade servers you
want to re-configure as normal KVM ports.
46