CommandCenter Secure Gateway - Admin Guide - Version ... - Raritan

Chapter 16: Diagnostic Console
This screen is split into three main areas:
• The top displays read-only information about the accounts on the
system.
• The middle section displays the various parameters related and
pertinent to each ID, along with a set of buttons to allow the
parameters to be updated or new passwords provided for the
accounts.
• The lower area restores the password configuration to Factory
Defaults (or to how the system was initially shipped).
3. If you want to require a password for the Status account, select
Enabled underneath it.
4. For the Admin and Status accounts, you can configure:
Setting
User \ User Name
Last Changed
Expire
Mode
Min Days
Max Days
Warning
Max # of Logins
UPDATE
New Password
Description
(Read-only). This is the current user name or ID for this account.
(Read-only). This is the date of the last password change for this
account.
(Read-only). This is the day that this account must change its
password.
A configurable option if the account is disabled (no login allowed), or
enabled (authentication token required), or access is allowed and no
password is required. (Do not lock out both the Admin and FS1
accounts at the same time, or you cannot use Diagnostic Console.)
The minimum number of days after a password has been changed
before it can be changed again. Default is 0.
The maximum number of days the password will stay in affect. Default
is 99999.
The number of days that warning messages are issued before the
password expires.
The maximum number of concurrent logins the account will allow.
Negative numbers indicate no restrictions (-1 is the default for status
login). 0 means no one can log in. A positive number defines the
number of concurrent users who can be logged in (2 is the default for
admin login).
Saves any changes that have been made for this ID.
Enter a new password for the account.
263