CommandCenter Secure Gateway - Admin Guide - Version ... - Raritan

Chapter 15: Advanced Administration
What is Active/Active mode?
Active/Active mode allows you to use CC-SG to manage devices and
nodes that are on two separate networks. In this mode, CC-SG manages
traffic between the two separate IP domains. Active/Active mode does not
offer failover. If either LAN connection fails, users will not have access.
See About CC-SG LAN Ports (on page 182) for the locations of the
Primary LAN and Secondary LAN ports on each CC-SG model.
Note: Clustering cannot be configured when using Active/Active mode.
Setup for Active/Active mode:
When implementing Active/Active mode for your CC-SG network:
• Each CC-SG LAN port must be connected to a different sub-network.
• Raritan devices must be connected to the Primary LAN only.
• Clients and nodes may be connected to either the Primary LAN or the
Secondary LAN.
• Specify at most one Default Gateway in the Network Setup panel in
CC-SG. Use Diagnostic Console to add more static routes if needed.
See Edit Static Routes (on page 249).
To configure Active/Active mode in CC-SG:
1. Choose Administration > Configuration.
2. Click the Network Setup tab.
3. Select Active/Active mode.
185