CommandCenter Secure Gateway - Admin Guide - Version ... - Raritan

Chapter 14: System Maintenance
6. Enter the number of minutes (from 0-720) that should elapse before
CC-SG performs the reset operation.
If specifying over 10 minutes, the broadcast message displays to
users immediately, and then repeats at 10 and 5 minutes before the
event occurs.
7. Click OK. A message appears to confirm the reset.
Do NOT power off, power cycle, or interrupt CC-SG when reset is in
progress. Doing this may result in the loss of CC-SG data.
Restarting CC-SG
The restart command is used to restart the CC-SG software. Restarting
CC-SG will log all active users out of CC-SG.
Restarting will not cycle power to the CC-SG. To perform a full reboot, you
must access Diagnostic Console or the power switch on the CC-SG unit.
1. Choose System Maintenance > Restart.
2. Type your password in the Password field.
3. Broadcast message: Type the message that will display to users who
will be logged off CC-SG.
4. Restart after (min): Enter the number of minutes (from 0-720) that
should elapse before CC-SG restarts.
If specifying over 10 minutes, the broadcast message displays to
users immediately, and then repeats at 10 and 5 minutes before the
event occurs.
5. Click OK to restart CC-SG.
171