CommandCenter Secure Gateway - Admin Guide - Version ... - Raritan

Chapter 15: Advanced Administration
b. Periodic: Use the up and down arrows to select the Start time at
which the task should begin. Type the number of times the task
should be executed in the Repeat Count field. Type the time that
should elapse between repetitions in the Repeat Interval field.
Click the drop-down menu and select the unit of time from the list.
c. Daily: Click the Every day radio button if you want the task to
repeat every day of the week. Click the Every weekday radio
button if you want the task to repeat each day from Monday
through Friday.
d. Weekly: Use the up and down arrows to select how many weeks
should elapse between task executions, then select the checkbox
next to each day on which the task should recur each week that it
runs.
e. Monthly: Type the date on which the task should execute in the
Days field, and then select the checkbox next to each month in
which the task should recur on the specified date.
f. Yearly: Click the drop-down menu and select the month in which
the task should execute from the list. Use the up and down arrows
to select the day in that month on which the task should execute.
8. For Daily, Weekly, Monthly, and Yearly tasks, you must add a start
and end time for the task in the Range of recurrence section. Use the
up and down arrows to select the Start at time and Start date. Click the
radio button next to No end date if the task should recur as specified
indefinitely, or click the radio button next to End date, and then use the
up and down arrows to select the date at which the task should stop
recurring.
9. Click the Retry tab.
10. If a task fails, CC-SG can retry the task at a later time as specified in
the Retry tab. Type the number of times CC-SG should retry to
execute the task in the Retry count field. Type the time that should
elapse between retries in the Retry Interval field. Click the drop-down
menu and select the unit of time from the list.
Important: If you are scheduling a task to upgrade SX or KX devices,
set the Retry Interval for more than 20 minutes, because it takes
approximately 20 minutes to successfully upgrade these devices.
11. Click the Notification tab.
12. Specify email addresses to which a notification should be sent upon
task success or failure. By default, the email address of the user
currently logged in is available. User email addresses configured in
the User Profile. To add another email address, click Add, type the
email address in the window that opens, and then click OK. By default,
email is sent if the task is successful. To notify recipients of failed
tasks, select On Failure.
13. Click OK to save your changes.
217