CommandCenter Secure Gateway - Admin Guide - Version ... - Raritan

Chapter 15: Advanced Administration
Command syntax Device ID value You should type
ssh -id 100 ssh -id 100
• The default escape character is a tilde followed by a period. For
example:
~.
See End SSH Connections (on page 230) for details on using the
escape character and the exit command.
You may have problems using the escape character in the Linux
terminal or client. Raritan recommends that you define a new escape
character when establishing a port connection. The command is
connect [-e ] [port_id]. For example, to define
"m" as the escape character when connecting to the port with id 2360,
type connect -e m 2360.
Create an SSH Connection to a Serial-Enabled Device
You can create an SSH connection to a serial-enabled device to perform
administrative operations on the device. Once connected, the
administrative commands supported by the serial-enabled device are
available.
Note: Before you connect, ensure that the serial-enabled device has been
added to the CC-SG.
1. Type listdevices to ensure the serial-enabled device has been
added to CC-SG.
228